Do not exceed the recommended payload capacity for your model.
#Bike rack for rad power bikes free#
Check that all cables are free of moving parts and that the front wheel can turn freely. Rotate the handlebar fully to check that the accessory does not block the wheel and does not pinch any cables.Use a 4 mm Allen wrench to tighten all bolts evenly, by tightening partway then switching to another bolt until they are all securely tightened.Thread into the mounting point on the rack by hand. Pass the shorter bolt through the mounting hole on the accessory, and through the mounting point on the rack.
#Bike rack for rad power bikes install#
To install an accessory on the rear rack of all other models, and the front rack of all models:.Use a 5 mm Allen wrench and a 10 mm wrench to tighten all bolts evenly, by tightening partway then switching to another bolt until they are all securely tightened.On the underside of the rear rack, pass another washer over the bolt end, then thread on a locknut.Pass the longer bolt through the mounting hole on the accessory and through the mounting hole on the rack.To install an accessory on the rear rack of the RadMission or selected RadRunner models:.Large platform: Orient the platform so the larger side is facing away from the rider and the flat side of the platform will sit flush against the rack.Small or large basket: Orient the basket so the X is facing away from the rider (forward if installed on the front rack and backward if installed on the rear rack).Orient the accessory and place it in position. Make sure the accessory is not pinching any cables.To install an accessory on the rear rack of all other models, and the front rack of all models: Locate the 4 shorter bolts. Pass a split washer, a small flat washer, and then a large flat washer over each of the 4 shorter bolts and set them aside.Pass a small washer over each of the 4 longer bolts and set them aside with the remaining 4 small washers and the 4 locknuts. To install an accessory on the rear rack of the RadMission or selected RadRunner models: Locate the 4 longer bolts.Locate and prepare the mounting hardware.
If installing on the RadWagon rear rack, remove the wooden deck hardware and set the mounting hardware and deck aside. Choose where you want to install the basket or platform. Ensure you have a front or rear rack installed before attempting to install the accessory.Get the bike ready for installation. Press and hold MODE or the power button to turn off the bike.Ensure the tool is pressed firmly into the bolt head and turn slowly to prevent stripping. Use the appropriate head size and type of tool for your bolts. Notice: Hardware may vary (bolt head style) and/or require different tools.
0 kommentar(er)
